SunStar Ceramic Heater SG10-L Gas Infrared Propane Gas. 100,000 BTU

Description

SunStar Heating Products SG10-L Gas Infrared Propane Gas Ceramic Heater 100,000 BTU, it is missing the reflector (43847030), it comes with what’s pictured, local pick up only.
Description
The SunStar Heating Products ceramic heater is ideal for spot heating or area heating of remote locations, farm buildings, shops, service areas, pump houses or other hard-to-heat spaces, providing both fuel efficiency of radiant heat and installation flexibility (not recommended for car washes). this is an energy-saving direct spark ignition heater and can be controlled by a line voltage or 24V thermostat (sold separately). may require the following second stage regulators prior to the heater based on gas supply pressure: a regulator up to 2 PSIG line pressure or a regulator above 2 PSIG line pressure (both sold separately). not certified or approved for residential use. Indoor use only. U.S.A. Note: please review the detailed installation & operating instructions (attached) for other specific installation requirements (gas Type, gas pressure, ventilation etc.) prior to purchasing the heater.
MIN. CLEARANCE TO COMBUSTIBLE 30 DEGREE ANGLE INCH Front 61, Rear 49, Below 129
MIN. CLEARANCE COMBUSTIBLES AT HORIZONTAL INCH Side 49, Ceiling 65, Below 129
ASSEMBLY Assembled
CONSTRUCTION Aluminized Steel / Aluminum Reflectors
MANUFACTURER PART# SG10-L
BTU HIGH 100000
VOLTAGE 120
GAS INLET PRESSURE MAX. WATER COLUMN INCHES 14
GAS INLET PRESSURE MIN. WATER COLUMN INCHES 11
NUMBER OF BURNERS 3
FUEL TYPE Propane
IGNITION TYPE Direct Spark
BURNER PRESSURE W.C. INCHES 10
CONNECTION TYPE NPT Female
AMPS HIGH 0.4
Features & details
100, 000 btu
Dimpled tile assembly design for increased radiant efficiency
Design certified for angle mounting up to 30 degrees
Equipped with 100 percent gas shut-off safety control
Constructed of aluminized steel for corrosion resistance